Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Por um escritor misterioso
Descrição
I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan
Blobs on overhangs - Troubleshooting - Bambu Lab Community Forum
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
How to show Overhangs in Bambu Studio @BambuLab #bambustudio #3dprinting #3dslicer
AMS results for Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
New bambu lab version issue with some sloped/overhangs : r/BambuLab
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
Are arc overhangs coming to Bambu studio? - Bambu Lab Software - Bambu Lab Community Forum
How to do support structures for small round overhangs in Bambu Studio : r/BambuLab
de
por adulto (o preço varia de acordo com o tamanho do grupo)
